Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Lombard
A dryer vent cleaning in Lombard typically runs $149 to $279 for a standard single-story run, and most homes in the 60148 zip code are done in under two hours. Before we send a tech out, we need to know one thing about your house: does the dryer exhaust out a sidewall, or does it chase up through an old masonry chimney? That single detail changes what the job involves here more than anything else. If you’re not sure, call (855) 382-3714 and we’ll walk you through what to look for.
Summit Peak works throughout Lombard, from the older bungalows south of the Metra tracks to the brick ranches off Grace Street and the split-levels west of I-355. Our techs know this housing stock. They know the crawlspaces, the shared flues, and the shortcuts previous owners took in the 1970s and 80s. That local knowledge is the difference between a duct that gets brushed and a vent system that actually moves air again.
Why Summit Peak Chimney Sweep Is Lombard’s Preferred Dryer Vent Cleaning Company
Every week, our techs walk into Lombard basements and find the same quiet problem: a dryer that’s been pushed through two cycles for years because the vent behind it was slowly choking shut. Homeowners in older homes don’t always realize the issue until the laundry room smells like scorched lint or the dryer shuts down on its high-limit switch. We’re set up to find the full picture, not just clear the easy part of the pipe.
Summit Peak is led by Norm Bledsoe, and the company runs on a simple rule: nothing gets recommended without camera footage the homeowner can see on the spot. That matters in Lombard specifically because so many vents terminate in old clay flues that also carry a furnace or water heater draft. A quick brush job won’t reveal that. Our techs scope the full chase with a camera on every cleaning. If the duct is clear and just dirty, we say so. If the termination is wrong and creating a fire or carbon monoxide risk, you’ll see the video before anyone asks you to spend a dollar.
For Lombard homeowners, having a specialist who carries professional-grade venting materials makes the call simpler. We stock products from Gelco, Famco, and Olympia Chimney, which means when a crushed foil flex needs to be replaced with rigid duct, or a wall termination needs a proper damper and cap, the parts are on the truck. We don’t improvise with whatever’s at the hardware store. We carry what the job actually needs.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Lombard
Dryer Vent Cleaning
Standard cleaning for Lombard homes involves removing the transition hose behind the dryer, running a rotary brush and HEPA vacuum through the full duct run, and clearing the exterior termination. The difference here is what we find at the far end. In the subdivisions west of I-355, a dryer usually vents straight through a rim joist. In the older core of Lombard, where 1920s bungalows and 1950s brick ranches dominate, the duct often turns upward and disappears into a masonry chase. We clean the entire run, not just the accessible flex section.
The job starts with a walkthrough. We check the dryer’s exhaust temperature, pull the transition, inspect the first elbow where lint packs hardest, then run the brush through the full length. Most finishes take between 60 and 90 minutes. If you’ve never had the vent cleaned, or you don’t know when it was last done, this is where you start.
Dryer Vent Camera Inspection
Older Lombard homes need more than a brush. When a duct runs through a crawlspace and up a chimney chase, the lint blockage is often somewhere you cannot see from either end. Our camera inspection scopes the entire run, from the dryer connection to the termination point. We look for crushed flex, separated joints, trapped debris, and the big one in this village: ducts that don’t actually terminate outdoors.
This is the step that protects you from being sold work you don’t need. On a postwar brick ranch off the older village core, a homeowner called us because the dryer had stopped drying in one cycle and the room smelled faintly hot. The visible flex was fine. The camera showed the reality: a foil duct crushed flat behind the dryer, and a termination inside an abandoned clay flue that still carried the water heater’s draft. Lint, heat, and moisture were mixing inside a stack never meant for a dryer. Without the camera, that hazard stays hidden. We showed the footage, capped the unused flue, and rerouted the vent to a proper wall termination.
Dryer Vent Rerouting and Termination
Sometimes cleaning isn’t enough because the vent was installed wrong from the start. In Lombard’s pre-1980 housing stock, it’s common to find dryers vented into an old chimney flue that was abandoned when the furnace was upgraded. That may have passed code decades ago, but it is not a safe long-term setup. Lint coats the tile liner, moisture condenses inside the chase, and if a bird or squirrel has nested in the open top, the entire stack becomes a fire hazard.
We handle reroutes with rigid duct and proper wall or roof terminations. We also install the right dampers and caps so the vent stays clear and animals stay out. The work is straightforward when it’s done correctly with the right materials, and that’s what we stock. Gelco and Famco components for terminations and caps, not whatever the local hardware aisle happens to have.
Dryer Vent Repair
Most repair calls in Lombard are for crushed flex, separated joints, or terminations that have rusted or been torn loose by storms. The mature tree canopy around the older village core and the East Branch DuPage River corridor means a lot of debris loading on exterior vent caps. Leaves, twigs, and the occasional squirrel nest block the flapper and push heat back into the duct. We replace damaged sections with rigid pipe where possible, secure loose joints, and install animal-proof caps that let air out and nothing in.
We also repair what a brush can’t fix: sagging duct runs in crawlspaces, disconnected elbows behind walls, and terminations that vent into soffit boxes where lint accumulates against the roof decking. These are common in Lombard’s split-levels and ranches where the laundry room sits mid-house and the original vent path was an afterthought.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Lombard
We work on all dryer makes and models, and the parts we install come from suppliers that professional venting contractors actually rely on. When a Lombard home needs a new wall cap, a backdraft damper, or a rigid duct section, we use components from Famco and Gelco. When a termination passes through a masonry wall or chimney chase, our techs have the right sealing and flashing products on hand. Dryer Vent Cleaning performed with professional-grade materials lasts longer and seals correctly the first time. That’s what you’re paying for, and it’s the standard we hold on every job in Lombard.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Lombard Homes
- Foil or vinyl flex crushed behind the dryer. The laundry rooms in Lombard’s older bungalows and ranches are often tight, and homeowners push the dryer back to gain floor space. The flex accordions against the wall, lint packs into the first elbow, and the vent quietly strangles itself over a few years.
- Dryer vented into a shared or abandoned clay flue. This is the Lombard-specific failure mode we see most often in homes built before 1980. The flue may still serve the furnace or water heater, or it may be open at the top where chimney swifts have nested. Either way, lint and exhaust gas do not belong in that stack.
- Deteriorated mortar crowns around the flue terminus. Northeastern Illinois freeze-thaw cycles crack the crown, water seeps into the chase, and debris works its way down into the vent. The duct clogs from the top down, season after season, even when the dryer-side lint load is normal.
- Chimney swifts nesting in uncapped flues. These federally protected birds use open clay flues on older Lombard homes from spring through August. The nest material and droppings fall into the vent path, and we can’t legally remove an active nest. Scheduling a cleaning and capping the flue outside of nesting season prevents the problem entirely.
Pricing for Dryer Vent Cleaning in Lombard, IL
In Lombard, a standard dryer vent cleaning for a single-story home with a sidewall or roof termination typically runs $149 to $229. Two-story homes, long duct runs over 15 feet, or vents that terminate through a chimney chase usually run $199 to $279 because the access and the scope of work increase. If a camera inspection reveals a crushed flex, a separated joint, or a bad termination, the repair cost depends on what we find, but we’ll show you the footage and give you a written number before any work begins. A new wall cap or damper from Famco or Gelco is usually an additional $35 to $75 installed. The estimate is free. Call (855) 382-3714 and we’ll give you an exact quote over the phone once we know your vent’s layout.
A dryer vent is a chimney you never think about, and in Lombard it deserves the same inspection discipline we apply to fireplaces. The cleaning is the easy part. Knowing what the vent actually does after it leaves the laundry room is the part that keeps your house safe.
We Also Serve Cities Near Lombard
Summit Peak handles dryer vent cleaning and chimney work across central DuPage County. If you’re in Villa Park, Glen Ellyn, Oak Brook, or Oakbrook Terrace, we can schedule a visit the same week and bring the same camera equipment and professional-grade materials. Our service area extends throughout the Dryer Vent Cleaning in Lombard region and the surrounding villages, so if you’re just outside Lombard proper, give us a call at (855) 382-3714 and we’ll confirm availability.
Serving Lombard, IL — Our Local Coverage Area
We’re based in the Lombard area and know this community well, and we also offer Lombard HeatShield service. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Lombard
Yes, in most cases it is. Dryer exhaust carries hot, moist air full of lint. When that air pushes into an old masonry flue, the lint coats the clay tiles and the moisture condenses on the interior walls. If the flue also serves a furnace or water heater, the exhaust gases mix and backdrafting becomes a carbon monoxide risk. If the flue is abandoned and open at the top, birds and debris get in. In Lombard’s older housing stock, this configuration is common, and the first step is always a camera inspection to see exactly where the duct terminates and what condition the flue is in. Call (855) 382-3714 to schedule a scope and we’ll show you what we find.
Once a year for most households, and twice a year if you have a long duct run, a masonry chase termination, or a big family doing multiple loads a day. Lombard’s mature tree canopy and freeze-thaw cycles mean exterior terminations gather debris faster than in newer subdivisions to the west. If your dryer takes a full cycle to dry a normal load, the vent is already telling you it’s blocked. Don’t wait for the high-limit switch to trip. Give us a call at (855) 382-3714 and we’ll get it cleared.
No, and that’s a fair question. We do not recommend relining or full replacement without camera evidence showing why it’s necessary. Lombard has plenty of older masonry flues that are perfectly functional for the job they were designed for, which is venting a wood-burning fireplace. The problem is when a dryer was pushed into that flue decades ago and the setup was never corrected. If the camera shows a clean, intact flue that simply needs to be properly rerouted, we’ll tell you that. If the flue is deteriorated and genuinely unsafe, we’ll show you the footage and walk through your options. No scare tactics, no automatic upsell. The number is (855) 382-3714.
Chimney swifts are federally protected migratory birds that nest in open, uncapped clay flues from spring through August, and Lombard’s older homes are exactly the kind of housing they target. If your dryer vents into an uncapped flue, the swifts can build a nest directly in the exhaust path. The nest material blocks airflow, and droppings acidify the flue interior. Federal law prohibits disturbing an active nest, so if we find one during the spring or summer, the cleaning has to wait and the vent must be capped after the birds leave. Scheduling a cleaning and cap installation outside of nesting season is the only way to prevent the cycle. Call (855) 382-3714 to check availability.
The vent is partially or fully blocked. When moist air can’t escape, it leaks back into the laundry room, the dryer runs hotter and longer, and the high-limit switch eventually shuts the machine down. In Lombard homes with sidewall terminations, the flapper is often stuck shut from lint or a bird nest blocking the outlet. In homes with chimney chase terminations, the blockage is usually deeper in the flue. Either way, the fix starts with pulling the flex and running a camera. We’ll find the obstruction, show you what we’re seeing, and clear or repair the affected section. Call (855) 382-3714 for a free estimate and we’ll schedule a visit.
Written by Norm Bledsoe, Owner at Summit Peak Chimney Sweep, serving Lombard and the surrounding DuPage County villages.